Pool fencing in Chatswood and Willoughby
Pool Fence Doctor builds and fixes pool fences across Willoughby City, from Chatswood and Artarmon to the bushland edges of Castlecrag and Middle Cove, 7 to 11 km from Peter's base.
Dots mark the councils Peter covers; the ring is 15 km from Ryde. Swipe the map sideways to see it all. Map: Google. Open the area in Google Maps
Castlecrag's Griffin area: where the pool barrier goes
Willoughby's heritage plan has the most specific pool barrier rule in Peter's whole area. In the Griffin Heritage Conservation Area at Castlecrag, built to sit within the landscape in sandstone and Knitlock, there is no fencing in front of the house beyond very low fencing of 300mm, and no fences or screens next to public reserves and pathways.
So a pool barrier cannot run along a boundary that adjoins a reserve or pathway. It must be set back 3m from that boundary, be no higher than 1500mm, and leave a landscaped strip at least 3m wide to the side or rear boundary, and council writes these into the consent for any new pool. A frameless glass or slim aluminium run, set into the garden, is what usually fits.
Bushfire: non-combustible, not hardwood
Willoughby's bush fire prone land map, certified in 2017, marks high-risk bushland with 100m and 30m buffers around it, and much of Castle Cove, Middle Cove, Castlecrag and Northbridge backs onto it. Here the plan goes a step further than the NSW exempt rules, which also allow hardwood: a fence on bush fire prone land in Willoughby must be built of non-combustible materials. Glass and aluminium pool fences qualify; timber does not.
Fence heights across the rest of Willoughby
Behind the building line fences stop at 1.8m, and stepped fences on a slope may reach 2.2m at each step. Out the front, and on the corner of two street frontages, fences stop at 1.2m and must be at least 20% open above 400mm. Front fences between 1.2m and 1.8m are set back at least 1m with planting, and a solid 1.8m street fence is allowed only in set cases, such as a house on a busy road. Pools sit behind the building line with the water line at least 1m from side and rear boundaries.
In the Innisfallen Castle Estate at Castle Cove, fences may not come closer to the street than the house, with one stated exception: a safety fence around a swimming pool. Dividing fences there stay at 1.8m, and council and the neighbours must agree in writing to anything higher.
Heritage streets, the foreshore and trees
The plan sets controls for 12 heritage conservation areas, from Artarmon and Naremburn to North and South Chatswood and Willoughby Park, where low front fences and garden settings are to be kept. On heritage properties, masonry fences stop at 700mm and open pickets at 1200mm. Along Middle Harbour, foreshore building lines keep new structures back, and retaining walls there stay under about 1m in sandstone or timber, never bare concrete block. Fences on overland flow paths or floodways must let water and debris pass.
A permit is needed to prune or remove a tree over 4m tall, with a trunk girth over 600mm at 1.4m, or a crown over 3m, and in a conservation area a development application instead. Approved permits are displayed on the front boundary for 72 hours before and during the work. Council's pool safety page adds the everyday rules: nothing climbable near the fence, and trees, shrubs and creepers trimmed well away from it.
Which Willoughby suburbs does Peter cover?
Chatswood is the nearest, about 7 km from Ryde. Castlecrag, on the water at the far end of the city, is the furthest Peter goes here.
- Chatswood7 km from Ryde
- Willoughby7 km from Ryde
- Artarmon7 km from Ryde
- St Leonards8 km from Ryde
- Naremburn9 km from Ryde
- Middle Cove10 km from Ryde
- Castle Cove10 km from Ryde
- Northbridge10 km from Ryde
- Castlecrag11 km from Ryde
Where do these rules come from?
These facts come from Willoughby City Council's own pages and its Development Control Plan 2023 (Parts B, C, G and H, June 2025 versions), its certified bush fire prone land map, its pool safety page and the NSW Government's Data.NSW council listing.
- Willoughby City Council: Development Control Plan 2023
- Willoughby City Council: bushfire prone land map
- Willoughby City Council: swimming pool safety
- Data.NSW: Willoughby City Council
Nearby, see pool fencing in North Sydney, pool fencing in Lane Cove and pool fencing in Mosman, or every council on the areas map.
Pool fencing in Chatswood and Willoughby: questions
Where can a pool barrier go in Castlecrag's Griffin conservation area?
Not on a boundary next to a public reserve or pathway. Willoughby's heritage plan says the barrier must be set back 3m from that boundary, be no higher than 1500mm and leave a landscaped area at least 3m wide.
Can a fence on bush fire prone land in Willoughby be timber?
Willoughby's Development Control Plan says a fence erected on bush fire prone land must be constructed of non-combustible materials.
Ask about a fence in Chatswood and Willoughby
Tell Peter what failed, or what you want built. He replies with a quote and, where there is one, a cheaper way to comply.
The notice
The council or certifier's written notice, if you have one.
A few photos
The fence, the gate and anything near them.
The gate
Whether it shuts and latches on its own from any position.
Request a quote online
Peter takes every quote request through one online form, so each enquiry, notice and photo stays together. It asks for:
- Your name, email and phone number
- The address of the pool
- What failed, or what you want built
- The notice and photos, attached from your phone or computer
Opens Pool Fence Doctor's quote request on ServiceM8. How your details are used
Prefer to talk? Call 1300 304 800, Monday to Friday, or see every way to reach Pool Fence Doctor.